I/O Configuration - UNI-T UT8805E Manual

Menu Description
I/O The interfaces setting
System System information and setting
Time System time setting
Upgrade Firmware upgrade
Default settings restorable for all of the configurable items,
Default such as function, reading rate, input impedance, relative
Setting value, threshold, beeper, probe type, temperature unit,
display mode, etc., see the menu for details

2.5.1 I/O Configuration

Press [I/O] to set the interfaces parameters as Figure 2-32.

LAN Setting
Remote operation is allowed through LAN interface. Users can check or set the current IP address, subnet
mask and gateway in network setting.
After opening the operation menu of auxiliary system function setting, press [I/O] to open the network and
select [LAN] to enter the following interface as Figure 2-33, and change the setting by direction buttons.
。
LAN parameters setting
Functions menu
DHCP
IP address
Subnet mask
Gate
Apply
Return
Figure 2-32 Interface I/O setting
Figure 2-33 Interface of LAN setting
Description
Dynamic host configuration protocol, which can be turned on/off
IP address setting
Subnet mask setting
Gateway setting
Apply current setting and return to previous menu
Do not save modification and return to previous menu
29
UT8805E Benchtop Digital Multimeter