Table of Contents
Advertisement
IDE RAID Connectors: IDE3 & IDE4
The mainboard offers a low-cost RAID (Redundant Array of Independent
Disks) solution by integrating two IDE RAID connectors that support PIO
mode 0-4, Bus Master, and Ultra DMA 33/66/100 modes. The IDE RAID con-
nectors allow you to connect Ultra ATA/DMA hard disks and use RAID tech-
nology for high performance, data security and fault tolerance. The connec-
tors support RAID 0 (striping) and RAID 1 (mirroring).
IDE RAID Connectors
- You can connect a Master and a Slave drive to each IDE RAID connector.
- For more information on IDE RAID, please refer to IDE RAID Manual.
- Please note that only the two master HDDs will adopt RAID function.
TIP:
If you install two hard disks on cable, you must configure the
second drive to Slave mode by setting its jumper. Refer to the
hard disk documentation supplied by hard disk vendors for jumper
setting instructions.
Hardware Setup
2-15
Advertisement
Table of Contents
