MSI Micro ATX Manual page 63

Blank Screen
DPMS
Video Off In Suspend
This setting determines whether the monitor will be turned off during suspend
mode. Setting options: Yes, No.
Soft-Off by PWR-BTTN
This feature allows users to configure the power button function. Settings are:
Instant-Off
Delay 4 Sec.
Modem Use IRQ
This setting determines the IRQ which the MODEM can use. The settings are:
3, 4, 5, 7, 9, 10, 11, NA.
Suspend Mode
After the selected period of system inactivity, all devices except the CPU shut
off. Settings are Disabled, 1 Min, 2 Min, 4 Min, 8 Min, 12 Min, 20 Min, 30
Min, 40 Min and 1 Hour.
HDD Power Down
If HDD activity is not detected for the length of time specified in this field, the
hard disk drive will be powered down while all other devices remain active.
Settings are Disabled and 1 through 15 Min.
Wake-Up by LAN/Wake-Up by Ring
These settings specify whether the system will be awakened from power sav-
ing modes when activity or input signal of the specified hardware peripheral or
component is detected.
Note: To use the function of "Wake-Up by Ring" and "Wake-Up by
LAN", you need to install a modem/LAN card supporting power on
function.
and write blanks to the video buffer.
This option only writes blanks to the video buffer.
Initial display power management signaling.
The power button functions as a normal power-on/-
off button.
When you press the power button, the computer
enters the suspend/sleep mode, but if the button is
pressed for more than four seconds, the computer is
turned off.
3-21
®
AWARD BIOS Setup