Bail Switch Replacement - Toro 20363 Service Manual

Bail Switch Replacement

Bail Switch Removal
Motor: Service and Repairs
The shoulder bolt is critical if ever removed, replacement part only sold as
assembly.
1. Remove the battery from the power head assembly.
2. Remove the 8 (6 top-around the battery cavity and 2 on the bottom rear) (1/4
x 1.0 inch) flange screws securing the power head upper shroud to the lower
shroud. Remove the power head upper shroud.
g293756
3. Remove the 4 (T-20) torx screws from the motor fan shroud.
g293757
4. Disconnect the 2 connectors from the battery receiver assembly to the motor
driver. Disconnect the positive first, then the negative.
Figure 137
Figure 138
Page 10–18 60v WPM Service Manual
3429-828 Rev A