Sunrise Medical Sopur Easy Life RT Directions For Use Manual page 43

Angle-Adjustable Footboard
The footboard can be flipped up to make it easier to transfer to
and from the chair, (Fig. 6.13 - 6.14.1).
This can be adjusted to alter the angle to the ground.
Tighten screw (1) on the outside. By loosening the clips (2) the
footboard can be moved to three positions both forwards and
backwards. To do this, the footboard must be flipped up. Make
sure that after any adjustment work, all screws are tightened
correctly (see the page on torque). Ensure that you maintain the
minimum gap to the floor (25 mm).
Fig. 6.13
1
Footrest - Plastic
Footplates:
The footplates can be flipped up to make it easier to transfer to/
from the chair.
Lower Leg Length:
For users with longer legs, the leg support can be lowered to
the appropriate level by using the screws. Loosen the screws,
push the tubes to the desired position and then re-tighten the
screws (see section on torque).
There must always be a minimum gap of 25 mm between the
footplates and the ground. (Fig. 6.15)
Sopur Easy Life RT Rev.F
Fig. 6.14
2
Fig. 6.15
>25 mm
Footboard
Angle-Adjustable Footboard
This can be adjusted to alter the
angle to the ground. Release screw,
pull it inwards, set the desired angle
and then push it on. After making
the adjustment, re-tighten the
screw. Make sure that after any
adjustment work, all screws are
tightened correctly (see the page on
torque).
Ensure that you maintain the
minimum gap to the floor (25mm) (Fig. 6.16).
Hanger And Latch
The legrests can be swung inwards under the seat sling or
outwards.
When fitting the legrests, the footrests must be pointing inwards
or outwards. Then rotate the legrest inwards, until it locks into
place. To remove, pull the lever (1), swing the footplate inwards
or outwards and then lift the legrest out. Make sure that the
legrest is locked into place correctly (Fig. 6.17 - 6.17.1).
WARNING!
• The legrests should not be used to lift or to carry the
wheelchair.
• When getting on or off the wheelchair, do not use the
footboards. These should be flipped up beforehand and
swung to the outside as far as possible.
Fig. 6.17
1
Fig. 6.16
Fig. 6.17.1
1
43