Tv Operation - Toshiba VTW2187 User Manual

NOTES:
• If SLEEP is pressed when the unit is the
REC mode, the clock will count down and
the picture will shut off at the set time, but
the recording continues.
• If the station being viewed stops
broadcasting, the TV will shut off after 15
minutes.
5N40301A [E] P10-13
1
2
3
MUTE
USING CH/PAGE
DISPLAY
CHANNEL RETURN
SLEEP
13

TV OPERATION

Press ON/STANDBY. Then press TV/VCR to select TV/VCR
mode.
Press Direct Channel Selection.
1-9: Press one of keys 1-9 as
required.
10-80: Press the two digits in
order from left to right.
The VOLUME can be adjusted to a
desired level by pressing VOL + or –.
The VOLUME control is represented
by a green bar on the screen.
To cut off the sound, press this
button once. The unit will be silenced
and the symbol "MUTE" will appear
on the screen. The muting can be
released by pressing MUTE again or
VOL + / – buttons.
OR
Press and release CH/PAGE
.
For channels to change properly,
they must be tuned into the unit
memory.
Press DISPLAY. The current time, channel number, real time
tape counter, tape speed and VCR operation will be indicated.
Press DISPLAY again to remove the call display.
TV/VCR mode or DVD mode
TV/VCR
11 : 30 SAT
Current time
01 : 30 : 21 SP
Real Time Tape Counter
This button allows you to go back to the last channel selected by
pressing CHANNEL RETURN. Press this button again to return
to the last channel you were watching.
To set the TV to turn off at a set time,
press SLEEP on the remote control.
The clock will count down 10 minutes
each time the button is pressed in the
order of 120, 110.....20, 10, 0. After
the sleep time is programmed, the
display will disappear and will
reappear every 10 minutes. To
confirm the sleep time setting, press
SLEEP once and the remaining time
will be a momentarily displayed. To
cancel the sleep time, press SLEEP
repeatedly until the display turns to 0.
12/24/04, 4:47 PM
+0
VOLUME 32
MUTE
BUTTON
or
CH 2
VCR operation
CH 2
Channel No.
Auto Repeat
Tape In
Tape Speed
SLEEP
90
13