To Park The Product; To Stop The Product; To Switch Off The Product; To Charge The Battery - Husqvarna AUTOMOWER 305 Operator's Manual

Note:
After the product has operated in the operating
Spot cutting , it will automatically start to cut in the
mode
Main area or Secondary area .
operating mode

4.3 To park the product

1. Push the STOP button to open the hatch.
2. Push the ON/OFF button for 3 seconds. The
display is lit up.
3. Enter the PIN code.
4. Push the PARK button.
5. Select an operating mode. Refer to
modes - Park on page 33 .
6. Push the OK button.
7. Close the hatch.
4.3.1 Operating modes - Park
• Park until further notice
Start with schedule
•
4.3.1.1 Park until further notice
Park until further notice for the
Use the operating mode
product to go back to the charging station. The product
will stay in the charging station until you select a new
operating mode.
4.3.1.2 Start again with next schedule
Use the operating mode Start again with next schedule
for the product to go back to the charging station. The
product will stay in the charging station until the next
Schedule setting.

4.4 To stop the product

1. Push the STOP button to make the product and
the cutting motor stop.

4.5 To switch off the product

1. Push the STOP button to open the hatch.
2. Push the ON/OFF button for 3 seconds.
3. Do a check that the indicator lamp on the keypad
is not lit to make sure that the product is switched
off.
1462 - 005 - 24.03.2021

4.6 To charge the battery

When the product is new or has been stored for a long
period, the battery can be empty and must be charged
Operating
before you can start the product. In the
the product cuts and charges automatically.
1. Push the ON/OFF for 3 seconds button to start the
product.
2. Put the product in as far as possible in the
charging station.
3. Make sure that the charging plates on the charging
station connects to the contact plates on the
product.
4. Do a check that the display shows the message
CHARGING to make sure that the product is
connected correctly to the charging station.

4.7 Adjust the cutting height

The cutting height can be varied from MIN (2 cm / 0.8
in.) to MAX (5 cm / 2 in.).
4.7.1 To adjust the cutting height
1. Push the STOP button to stop the product.
2. Open the hatch on the product.
3. Turn the cutting height adjustment knob on the
product to select a cutting height.
WARNING:
Only charge the product
using a charging station which is intended
for it. Incorrect use may result in electric
shock, overheating or leakage of corrosive
liquid from the battery.
In the event of leakage of electrolyte flush
with water and seek medical help if it comes
in contact with the eyes etc.
Main area mode,
CAUTION:
During the first weeks after
a new installation, the cutting height must be
set to MAX to avoid damaging the loop wire.
After this, the cutting height can be lowered
step by step every week until the desired
cutting height has been reached.
Operation - 33