Husqvarna AUTOMOWER 305 Operator's Manual page 13

2. Push the ON/OFF button for 3 seconds and make
sure the product is switched off. Check that the
indicator lamp on the keypad is not lit. This means
that the product is disabled. Refer to
ON/OFF button on page 32 .
3. Carry the product by the handle with the blade disc
away from the body.
2.3.4 Maintenance
WARNING:
switched off before any maintenance is
done. Use the plug to disconnect the
charging station before any cleaning or
maintenance of the charging station or the
loop wire.
1462 - 005 - 24.03.2021
To use the
The product must be
WARNING:
the charging station before any cleaning or
maintenance of the charging station or the
loop wire.
CAUTION:
Never use a high-pressure
washer or even running water to clean the
product. Never use solvents for cleaning.
Inspect the product weekly and replace any damaged or
Maintenance on page 35 .
worn parts. Refer to
2.3.5 In the event of a thunderstorm
To reduce the risk of damage to electrical components
in the product and the charging station, we recommend
that all connections to the charging station are
disconnected (power supply, boundary wire and guide
wire) if there is a risk of a thunderstorm.
1. Mark the wires to simplify reconnecting. The
charging station's connections are marked AR, AL
and GUIDE.
2. Disconnect all connected wires and the power
supply.
3. Connect all the wires and the power supply if there
is no longer a risk of thunder. It is important that
each wire is connected to the right place.
Use the plug to disconnect
Safety - 13