Operation; To Use The On/Off Button; To Start The Product - Husqvarna AUTOMOWER 305 Operator's Manual

4.1 To use the ON/OFF button

WARNING:
instructions carefully before you start the
product.
WARNING:
away from the rotating blades. Do not put
your hands or feet near or below the product
when the product is switched on.
WARNING:
when persons, especially children, or
animals are in the work area.
• Push the ON/OFF button for 3 seconds to switch
on the product. The product is active when the
indicator lamp on the keypad is lit.
• Push the ON/OFF button for 3 seconds to switch
off the product.
• The product is in power save mode if the indicator
lamp flashes. Push the ON/OFF button for 3
seconds to switch on the product.

4.2 To start the product

1. Push the STOP button to open the hatch.
2. Push the ON/OFF button for 3 seconds. The
display is lit up.
3. Enter the PIN code.
4. Push the START button.
5. Select an operating mode. Refer to
modes - Start on page 32 .
6. Push the OK button.
7. Close the hatch.

32 - Operation

4 Operation
Read the safety
Keep your hands and feet
Do not use the product
Operating
Note:
If the product is parked in the charging station,
the product will start to operate when the battery is fully
Schedule settings is set for operation
charged and if the
Note:
The first weeks after installation the perceived
sound level when cutting the grass may be higher than
expected. When the product has cut the grass for some
time, the perceived sound level is much lower.
4.2.1 Operating modes - Start
Main area
•
• Secondary area
Override schedule
•
Spot cutting
•
4.2.1.1 Main area
Use the operating mode Main area for the product to cut
and charge automatically.
4.2.1.2 Secondary area
Secondary area operating mode to cut secondary
Use
areas. You must move the product manually between
the main area and the secondary area. The product cuts
for a selected period of time or until the battery is empty.
Note:
You must put the product manually in the
charging station to charge the product when it is in a
secondary area. The product will move out from the
charging station and stop when the battery is charged.
You must select an operating mode to start the product.
Note:
If you will cut the main area after the battery is
charged, set the product to Main area mode before you
put the product in the charging station.
4.2.1.3 Override schedule
Override schedule to
Use the operating mode
Schedule settings for 24h or 3
temporarily override the
days .
Note:
It is not possible to cut more than the maximum
cutting time for each day. Refer to
the necessary operating time on page 23 .
4.2.1.4 Spot cutting
Spot cutting to cut a selected
Use the operating mode
area in a spiral pattern. You must move the product
manually to the selected area before you start the
cutting operating mode.
Make an estimate of
Spot
1462 - 005 - 24.03.2021