Husqvarna AUTOMOWER 305 Operator's Manual page 41

Message Cause
Trapped
The product is stuck in a small area behind a
number of obstacles.
Mower tilted
The product is tilted more than the maximum
angle.
Upside down
The product is leaning too much or has
turned over.
Needs manual charg-
The product is set to the
ing erating mode.
Next start hh:mm The schedule setting prevents the product
from operating.
The product has reached its maximum cut-
ting time for the day.
The clock or date in the product is not cor-
rect.
Today's mowing
The product has reached its maximum cut-
completed
ting time for the day.
Lifted The lift sensor has been activated as the
product has been lifted.
Electronic problem
Temporary electronic or firmware related is-
sue in the product.
Loop sensor prob-
lem, front/rear
Tilt sensor problem
Temporary problem
Invalid sub-device
combination
Temporary battery
problem
Safety function faulty
Connectivity problem Potential problem on the connectivity circuit
board in the product.
Connectivity settings
The connectivity settings was restored due to
restored
a fault.
Poor signal quality
The connectivity circuit board in the product
is assembled upside down, or the product it-
self is tilted or upside down.
1462 - 005 - 24.03.2021
Action
Check if there are any obstacles which make
it hard for the product to move on from this
location. Remove the obstacles or create an
island around the obstacles. Refer to
make an island on page 17 .
Move the product to a flat area.
Turn the product the right way up.
Secondary area op-
Put the product in the charging station.
Change the schedule settings. Refer to
Schedule on page 23 .
This behavior is normal and no action is re-
quired.
Set the time. Refer to
on page 30 .
This behavior is normal and no action is re-
quired. Refer to
essary operating time on page 23 .
Check that the product body can move freely
around its chassis. Remove or create an is-
land around objects that can cause the chas-
sis to be lifted. If the problem stays speak to
your authorized service technician.
Restart the product. If the problem stays
speak to your authorized service technician.
Restart the product. If the problem stays
speak to your authorized service technician.
Check and change the settings if needed.
Make sure that the product is not upside
down or tilted. If the problem stays speak to
your authorized service technician.
To
To set the time & date
Make an estimate of the nec-
Troubleshooting - 41