Table of Contents
Advertisement
The remote reset switch also functions in the same way as the
joystick mode switch when the wheelchair is not in motion. Refer to
6.8.9 Mode Switch (CMPJ+ Joystick, page 45).
6.8.8 Remote On/Off Switch
The remote On/Off switch input is located at the rear of the joystick
on the right side and allows the power switch to be operated by an
ability switch (normally open momentary switch with mono plug).
To use the remote On/Off feature, the Drive Select/On/Off switch
must be in the On position. Each activation of the ability switch will
alternately turn the joystick On or Off.
6.8.9 Mode Switch (CMPJ+ Joystick)
The mode switch [CMPJ+ Joystick G] is used to select the operating
mode for the wheelchair. The mode switch is located on the joystick.
A mode switch is needed whenever any of the following operating
modes are programmed:
*In these modes, Standby Select allows the reset switch to
be bypassed for users unable to activate the switch.
•
Environmental Controls (ECU 1, ECU 2, ECU 3, ECU 4)*
•
3 Speed Mode in Digital 3 Speed (Slow, Medium, Full)
•
Sleep Mode
•
RIM Mode*
•
Remote Drive Selection Mode*
•
Tilt/Recline Mode*
•
Information Center Display Selection (does not require Reset
activation at power up)
If any of the above modes are selected, the control will require
activation of the switch immediately after the power switch is turned
On in order to enter the drive mode. The second line of the LCD
will display - PRESS RESET.
1143155-R-01
6.8.10 Memory Card Slot
The memory card slot is used with the basic or professional memory
card for saving or reading wheelchair parameters.
6.9 When to Charge Batteries
Keep Batteries charged. When possible, DO NOT allow
battery charge to empty.
If battery charge becomes so low that no battery indicators
are lit, allow the batteries to charge overnight.
6.9.1 SPJ+, SPJ+ w/PSS and SPJ+ w/ACC Joysticks
The Information Gauge Display located on the front of the joystick
housing, it provides the state-of-battery charge, including notification
of when the battery requires charging. It also provides the following
information to the user on the status of the wheelchair:
•
Green LEDs are lit, indicating well charged batteries.
•
Amber LEDs are lit, indicating batteries are moderately charged.
Recharge batteries before taking a long trip.
•
Red LEDs are lit, indicating batteries are running out of charge.
Recharge batteries as soon as possible.
Usage
45
Advertisement
Table of Contents
