Table of Contents
Advertisement
7.3 Service Life
The expected service life is five years, presuming that the product is
used daily and in accordance with safety instructions, maintenance
instructions and intended use, stated in this manual.
7.4 User/Attendant Inspection Checklists
Every six months, and as necessary, take your wheelchair to
a qualified technician for a thorough inspection and servicing.
Weekly, monthly and periodic inspections should be
performed by user/attendant between the six month service
inspections.
Regular cleaning will reveal loose or worn parts and enhance
the smooth operation of your wheelchair. To operate
properly and safely, your wheelchair must be cared for just
like any other vehicle. Routine maintenance will extend the
life and efficiency of your wheelchair.
Refer to wheelchair base user manual for additional safety
inspection and troubleshooting information.
DANGER!
Risk of Injury, Damage or Death
Overinflation of tires may cause tires to explode.
– Inflate tire to the proper tire pressure (P.S.I. /
kilopascals) listed on the side wall of the tire.
– Only use wheelchair with tires at proper pressure.
– The wheels and tires should be checked periodically
for cracks and wear and should be replaced if
necessary.
7.4.1 Inspect/Adjust Weekly
q
Inspect all fasteners.
1143155-R-01
q
Ensure proper operation of powered functions (Example:
seating and legrests).
7.4.2 Inspect/Adjust Monthly
q
Clean upholstery and armrests.
q
Inspect seat positioning strap for any signs of wear. Ensure
buckle latches. Verify hardware that attaches strap to frame is
secure and undamaged. Replace if necessary.
7.4.3 Inspect/Adjust Periodically
q
Inspect all fasteners.
q
Ensure clothing guards are secure.
q
Ensure arms are secure but easy to release and adjustment
levers engage properly.
q
Ensure adjustable height arms operate and lock securely.
q
Ensure upholstery does not have any rips or tears.
q
Ensure armrest pad sits flush against arm tube.
q
Inspect foam handgrips for damage. If damaged, have them
replaced by a qualified technician.
q
Check center mount front riggings for loose fasteners.
Replace/tighten if necessary.
q
Check that all labels are present and legible. Replace if necessary.
q
Make sure drive lock-out operates properly.
q
Make sure elevate systems drive with reduced speed when seat
is in elevated position.
q
Make sure tilt mechanism and tilt tracks are clean.
q
Check that spreader bar mounting fasteners are tight.
q
Check back cane mounting fasteners and back mounting
fasteners are tight.
Setup/Maintenance
51
Advertisement
Table of Contents
