Table of Contents
Advertisement
10- Installation
10.3
11.4 Drain water connection
WARNING!
Use only the supplied hose set for the connection.
Never reuse old hose sets!
Only connect to cold water supply.
Before connection, check whether the water is clean and clear.
11.4.1
10.4.2
40
10.3 Adjusting the feet
Adjust all feet to achieve a complete level position with
enclosed spanner. This will minimize vibrations and
thus noise during use. It will also reduce wear and tear.
1
We recommend to use a spirit level for adjustment.
Floor should be as stable and flat as possible.
2
1. Loose the locking screw cap (1) with enclosed
2. Get the appliance to horizontal level through ad-
3. Use spanner to tighten the screw caps (1) to di-
Following connections are possible:
11.4.2
10.4.1
10.4.1 Drain hose to sink
10.4.2 Drain hose to waste water connection
spanner (Fig. 10.3).
justing the feet (2).
rection "tight".
1.Take out the drain pipe from the accessory bag.
2.Take off the rubber plug from the water outlet
connector at the back of washing machine.
3. Holding the front of the drain pipe with the hand,
insert it into the water outlet the lower back of
the washing machine (Fig. 10.4.1).
The drainage pipe ends into the floor drain in the
home(Fig. 10.4.2).
Advertisement
Table of Contents
