Table of Contents
Advertisement
6- Daily use
6.10.2.1
Note: Time delay
End time shall always be longer than programme cycle time.
When using liquid detergent, it is not recommended to activate the end time delay.
6.10.2.2.1
6.10.2.2.2 Combine a drying cycle with a washing cycle
Use function "Dry" to add a drying cycle at the end of the washing programme for most
of the programmes for the lower drum (refer to PROGRAMMES). This allows washing and
drying without interruption.
1. Set a programme and select required functions.
2. Set a drying time like it is described in section above.
3. Touch the
Note: Drying
Do not overload. The combination of washing and drying cycle only allows a maxi-
mum load of 8 kg , depending on the programme (see programme table).
If you want to wash the maximum load, you must interrupt the combined cycle at the end
of the wash programme and you must remove the surplus of load for joined drying cycle.
Note: Cool down cycle for drying cycle
The last part of the drying cycle occurs without heat to ensure the garments remain at
a temperature which does not damage them.
26
6.10.2.1 Selecting a time delay – End time delay
Use this function to start the programme with a delay.
1. Set a programme and select required functions.
2. Slide or touch within the option cube to set up
3. Touch
6.10.2.2 Drying
There are two possibilities to get dry laundry for the
lower drum:
6.10.2.2.1 Set programme Dry
1. Set programme "Dry".
2. Slide or touch within the option cube to set up
3. Touch
symbol to start the combined washing/drying programme.
time delay in steps of 1 hour from OFF-24h (Fig.
6.10.2.1).
symbol to start the programme; time
countdown begins.
drying time in steps of 30 minutes from OFF-210
minutes (Fig. 6.10.2.2.1). The dry programme st-
ops when laundry is dry.
symbol to start the drying programme.
Advertisement
Table of Contents
