Table of Contents
Advertisement
10.1 Preparation
Take the appliance out of the packaging.
Remove all packaging material including the poly-
styrene base (A) with part (B) (Fig. 10.1) and the
of childrens reach. While opening the package, wa-
ter drops may be seen on plastic bag and porthole.
This normal phenomenon results from water tests
in the factory.
Note: Packaging diposal
1.Water inlet, drain hose and blanking plugs are on the polystyrene base(A).
2.Keep all packaging materials out of childrens reach and dispose them in an environme-
ntally friendly manner.
10.2 Dismantle the transportation bolts and
packaging screws
The transportation bolts are designed for clamping
anti-vibration components inside the appliance during
transportation to prevent inner damage.
1. Remove the 2 packaging screws (A) on the rear
side and take out plastic spacers (C) from inner
side of the machine(Fig. 10.2-1 and 10.2-2).
2. Remove the 5 transportation bolts (B) and take
out plastic spacers (D) from inner side of the appli-
ance (Fig. 10.2-3).
3. Fill left holes with blanking plugs (E) (Fig. 10.2-4).
Note: Keep in safe place
Keep the transportation bolts in a safe place for later
install the bolts.
Moving the appliance
If the machine is to be moved to a distant location, re-
place the transportation bolts removed before instal-
lation to prevent damage:
1. Remove the blanking plugs.
2. Insert the plastic spacers and the transportation
bolts as well as the packaging screws.
3. Tighten the bolts with a spanner.
10- Installation
10.2-3
-
10.1
B
A
10.2-1
B
A
B
10.2-2
C
A
10.2-4
E
39
Advertisement
Table of Contents
