Dell OptiPlex GX50 User Manual page 86

84
In s ta l l i n g Up g r a d es
The pin-1 corner of the microprocessor is the beveled corner. The
pin-1 corner of the socket, labeled "1," is the front-left corner of the
socket as you face the front of the computer.
M i c r o p r o c e s s o r C h i p I n s t a l l a t i o n
1
1 Pin-1 corners of chip and socket aligned
NOTICE:
You must position the microprocessor chip correctly in the socket to
avoid permanent damage to the chip and the computer when you turn on the
computer.
Install the microprocessor chip in the socket.
8
If the release lever on the microprocessor socket is not fully
a
extended, move it to that position now.
With the pin-1 corners of the chip and socket aligned, align the
b
pins on the chip with the holes in the socket.
NOTICE: When you place the microprocessor chip in the socket, be sure that
all of the pins go into the corresponding holes on all sides of the socket. Be
careful not to bend the pins.
Set the chip lightly in the socket and make sure all pins are headed
c
into the correct holes. Because your computer uses a ZIF
microprocessor socket, there is no need to use force (which could