Husqvarna 331R Workshop Manual page 28

3. Attach the flywheel and the centrifugal clutch with
the spacers and screws as shown in the illustration.
Note: Turn the clutch until you can see the arrows
that show the direction of rotation.
4. Assemble the cables to the ignition module. Use the
2 screws and the 2 washers to assemble the ignition
module on the frame.
28 - Repair instructions
5. Use a feeler gauge to make sure that the distance
between the ignition module and the flywheel is
0.3-0.5 mm.
6. Install the remaining parts in the opposite sequence.
To disassemble the ignition system on page
Refer to
25 .
1296 - 001 - 27.09.2019