Husqvarna 331R Workshop Manual page 25

6. Put the spring into the new hole.
7. Put the cable with the open spring into the other slot
in the pliers. Close the pliers to bend the spring.
CAUTION: Make sure that the spring is bent
90 degrees along the cable.
8. Lubricate the cap with soap and water or equivalent
to make it easier to push it into position.
9. Push the cable into the spark plug cap.
1296 - 001 - 27.09.2019
10. Use the pliers or a screwdriver to align the spring
with the hole in the spark plug cap.
CAUTION: Be very careful to prevent
damage to the spark plug cap. A damaged
spark plug cap can cause an electrical
shock.
7.8.5 To disassemble the ignition system
1. Loosen the screws and remove the shaft assembly.
2. Remove the spark plug cap.
3. Remove the spark plug.
4. Use a piston stop to lock the axle.
Repair instructions - 25