Husqvarna 331R Workshop Manual page 27

12. Remove the screws, washers, cables and the
ignition module.
13. Remove the 2 screws and the 2 washers that hold
the centrifugal clutch. Remove the centrifugal clutch
and the 2 washers between the flywheel and the
centrifugal clutch.
14. Attach the flywheel puller, apart from the center unit,
on the flywheel.
1296 - 001 - 27.09.2019
15. Hold the flywheel puller and loosen and remove the
flywheel nut.
16. Attach the center unit to the flywheel puller. Hold the
flywheel puller and use a wrench to tighten the
center bolt until the flywheel releases.
7.8.6 To assemble the ignition system
1. Put some grease on the clutch screw, but not on the
thread.
2. Make sure that the keyway in the flywheel and the
keyway in the crankshaft are not damaged. Make
sure that the key is not damaged.
Repair instructions - 27