Table of Contents
Advertisement
Error Codes
ERROR CODES
Lt - Low Temperature Error
The unit is fitted with a frost protection device to avoid excessive formation of ice.
The unit will start automatically once the defrosting process is complete.
PF - Probe Failure Error
If this is displayed, contact customer service or your local authorised service centre.
Ft - Full Tank Error
Empty the water following the instructions in the "Water Drainage" Section.
Water Drainage
WATER DRAINAGE METHOD
When there is excess water condensation inside the unit, the unit will stop running
and show and 'Ft' (Full Tank) Error Code. This indicates that the water needs to be
drained using the following procedure:
Manual Drainage:
1. Unplug the unit from the power supply.
2. Place a bucket/pan (not supplied) under the
lower drain plug. See diagram 4.
3. Remove the lower drain plug.
4. The water will begin to drain out and collect in
the bucket/pan.
5. After the water is drained, replace the lower
drain plug.
Continuous Drainage:
1. Unplug the unit from the power supply.
2. Remove the lower drain plug. While doing this
some residual water may spill out, so please
have a bucket or pan ready to collect any
water.
3. Connect a drain hose (1/2" or 12.7mm - not
supplied). See diagram 55.
4. The water can be continuously drained
through the hose into a floor drain or bucket.
20
Advertisement
Table of Contents
