Touchpad - HP EliteBook 845 G7 Maintenance And Service Manual

3. Remove the fingerprint reader board from the computer (4).
Reverse this procedure to install the fingerprint reader board.

Touchpad

To remove the touchpad, use this procedure and illustration.
Table 6-8 Touchpad description and part number
Description
Touchpad button board
Touchpad
Touchpad with NFC antenna
Touchpad cable (included in Cable Kit)
Before removing the touchpad, follow these steps:
1. Prepare the computer for disassembly
2. Remove the bottom cover
3. Remove the battery (see
Remove the touchpad:
1. Disconnect the system board cable from the ZIF connector on the touchpad (1).
2. Disconnect the middle cable from the ZIF connector on the touchpad (2).
3. Disconnect the touchpad button board cable from the ZIF connector on the touchpad (3).
4. Disconnect the cable from the ZIF connector on the system board (4).
5. Remove the four Phillips M1.6 × 1.8 screws (5) that secure the touchpad to the computer.
(Preparation for disassembly on page
(Bottom cover on page
Battery on page 43).
33).
Component replacement procedures
Spare part number
M07106-001
M07108-001
M07109-001
M07101-001
33).
51