Rear Back-Up Camera / Dynamic Gridlines - Alfa Romeo STELVIO Owner's Handbook Manual

IMPORTANT
59) Projecting loads on the roof of the car
may interfere with the correct operation of
the camera. Before starting make sure the
load is correctly positioned, in order not to
cover the camera operating range.
60) If the windscreen must be replaced due
to scratches, chipping or breakage, contact
exclusively an Alfa Romeo Dealership. Do
not replace the windscreen on your own, risk
of malfunction! It is advisable to replace the
windscreen if it is damaged in the area of
the camera.
61) Do not tamper with nor operate on the
camera. Do not close the openings in the
aesthetic cover located under the interior
rear-view mirror. In the event of a failure
of the camera, contact an Alfa Romeo
Dealership.
62) Do not cover the operating range of the
camera with stickers or other objects. Also
pay attention to other objects on the bonnet
(e.g. a layer of snow) and make sure they do
not interfere with the camera.
63) The camera may have limited or absent
operation due to weather conditions such
as: heavy rain, hail, thick fog, heavy snow,
formation of ice layers on the windscreen
glass.
64) Camera operation may also be
compromised by the presence of dust,
condensation, dirt or ice on the windscreen
glass, by traffic conditions (e.g. cars that
are driving not aligned with yours, car
driving in a transverse or opposite way on
the same lane, bend with a small radius of
curvature), by road surface conditions and
by driving conditions (e.g. off-road driving).
192
Make sure the windscreen is always clean.
Use specific detergents and clean cloths
to avoid scratching the windscreen. The
camera operation may also be limited or
absent in some driving, traffic and road
surface conditions.
REAR BACK-UP CAMERA /
DYNAMIC GRIDLINES
(where provided)
DESCRIPTION
The Rear Back-up Camera is located on
the tailgate, near the opening button,
fig. 224.
162)
65)
224
Camera activation/deactivation
The function can be
activated/deactivated using the "Driver
Assistance" menu and then selecting
"Comfort" on the Connect system.
Activating the device
After activating the camera, it will be
possible to select one of the following
options:
"Activate"
"Cam Delay"
"Camera Guidelines"
Select "Activate" to activate the camera
view on the Connect system display.
Whenever reverse gear is engaged, the
Connect system display, fig. 225, will
show the area around the car, as seen by
the Rear View Camera.
225
NOTE The images are shown on the
display together with a warning message.
By activating the "Cam Delay" function,
07186V0001EM
the display could continue to show the
image transmitted by the camera for a
few more seconds, even if the reverse
gear is disengaged, afterwards the
display will show again the previously
active screen.
Controllare l'intera area circostante
07186V0060EM