Alfa Romeo STELVIO Owner's Handbook Manual page 189

213
Activation conditions
Once switched on, the system becomes
active only if the following conditions are
met:
the car speed is equal to or higher
than 40 mph (60 km/h) (the system
is deactivated at speeds higher than
110 mph/ 180 km/h);
the lane limit lines are visible at least
on one side;
there are suitable visibility conditions;
the road is straight or with wide radius
bends;
a suitable distance is kept from the
vehicle in front;
the direction indicator (for leaving the
lane) is not active.
SYMBOLS AND MESSAGES ON THE
DISPLAY
The Lane Departure Warning system also
advises the driver when the car changes
lane by showing symbols and messages
on the instrument panel display.
The message at the top of the display
remains active only until the main
reconfigurable area of the display is
activated (see the description in the
"Display" paragraph in the "Knowing the
instrument panel" section) pressing the
TRIP button located on the right lever of
the steering wheel.
07226S0001EM
Activating the main reconfigurable
area the messages related to the Lane
Departure Warning system will be shown
in this area.
When the system is active and the
lane limits have not been detected,
the display shows a specific grey icon,
fig. 214.
214
Exiting a lane with detection of a single
limit
When the system is active and only, for
example, the left lane limit has been
detected, the detected lane lights up in
white on the instrument panel display.
The system is ready to provide visual
warnings on the display in the event of
exiting the lane unintentionally (direction
indicator not activated) to the left,
fig. 215.
215
When the system detects that the car
has approached the lane line and is
about to overtake it, the left line on the
instrument panel display lights up yellow
and red fig. 216.
07226S0020EM
216
07226S0023EM
07226S0024EM
187