Using Additional Handsets - BT Synergy 2150 User Manual

Using additional handsets

Registering an additional Synergy handset with the base station
or de-registering a handset.
As well as your original handset,
you can register up to a further 4
additional handsets to your Synergy
2150 base station.
The system allows internal calls
between two handsets while a third is
making an external call.
Each additional handset you purchase
must be registered with the base
station.
Please note
Remember to charge the batteries of
new handsets for at least 16 hours.
When switched on, a new additional
handset will display Not SUB.
This tells you that the handset is not
yet registered with the base station.
To register a handset
At the base station:
Press the
Page
hold for at least 10 seconds,
until you hear the validation
tone, then release the button.
The In Use LED on the base
will flash repeatedly. You
must register the handset in
the next 10 minutes.
41
button and
PAGE
At the handset:
Options
Until the display flashes
Del
Registration
Options
Press to display the available
Del
base station names
If your handset is already
registered to another base,
then the display shows
next to the base name.
When a free base station
Options
number is displayed. Display
then shows
the base station number.
When the handset has
detected the base station
signal, it gives a confirmation
ring. You are asked to enter
the base station PIN.
Enter the 4-digit base
PIN
station PIN. The pre-set PIN
is 0000. (To change the PIN,
see page 38.)
The LED will stop flashing
Options
(unless there are new
messages).
The display shows the
normal standby setting when
the registration process is
completed.
.
BASE 1-4
.
Searching
and