IBM 5594-1AX Installation And User Manual page 32

16
Installation and User's Guide
Table 1. User settings (continued)
Submenu
On/Off settings Cold start
Forced reboot
Auto restart
Energy saving
Sleep mode
Remote command
Available settings Default settings
[Enabled] [Disabled] [Enabled]
Authorize the unit to
start on battery
power.
[Enabled] [Disabled] [Enabled]
If mains recover
during a shutdown
sequence:
If set to Enable,
shutdown sequence
will complete and
wait 10 seconds prior
to restart, if set to
Disable, shutdown
sequence will not
complete and restart
will occur
immediately.
[Enabled] [Disabled] [Enabled]
Authorize the unit to
restart automatically
when mains recover
after a complete
battery discharge.
[Enabled] [Disabled] [Disabled]
If Enabled, UPS will
shut down after 5
min. of back-up time,
if no load is detected
on the output.
[Enabled] [Disabled] [Disabled]
If Disabled, LCD and
communication will
turn OFF
immediately after
UPS is OFF.
If Enabled, LCD and
communication stays
ON 1h30 min. after
UPS is OFF.
[Enabled] [Disabled] [Enabled]
If Enabled, shutdown
or restart commands
from software are
authorized.