Advanced Wireless Settings - D-Link DIR-450 User Manual

Section  - Configuration
TX Rate:
Select the basic transfer rates based on the
speed of wireless adapters on your wireless
network. It is strongly recommended to keep
this setting to Auto.
Transmit Power:
Set the transmit power of the antennas.
Beacon Interval: Beacons are packets sent by an Access Point
to synchronize a wireless network. Specify
a value. 100 is the default setting and is
recommended.
RTS Threshold:
This value should remain at its default setting
of 2346. If inconsistent data flow is a problem,
only a minor modification should be made.
Fragmentation:
The fragmentation threshold, which is specified in bytes, determines whether packets will be fragmented. Packets exceeding
the 2346 byte setting will be fragmented before transmission. 2346 is the default setting.
DTIM Interval:
(Delivery Traffic Indication Message) 3 is the default setting. A DTIM is a countdown informing clients of the next window for
listening to broadcast and multicast messages.
Preamble Type:
Select Short or Long Preamble. The Preamble defines the length of the CRC block (Cyclic Redundancy Check is a common
technique for detecting data transmission errors) for communication between the mobile router and the roaming wireless
network adapters. Auto is the default setting. Note: High network traffic areas should use the shorter preamble type.
WMM Function:
WMM (Wi-Fi Multimedia) is QoS (Quality of Service) for your wireless network. Enable this option to improve the quality of
video and voice applications for your wireless clients.
D-Link DIR-450 User Manual

Advanced Wireless Settings