show power inline
The show power inline User EXEC mode command displays the information about inline power.
Syntax
show power inline [ethernet interface]
Parameters
•
interface — Valid Ethernet port. (Full syntax: unit/port)
Default Configuration
This command has no default configuration.
Command Mode
User EXEC mode
User Guidelines
There are no user guidelines for this command.
Example
The following example displays information about inline power.
Console> show power inline
Power: On
Nominal Power: 150 Watt
Consumed Power: 120 Watts (80%)
Usage Threshold: 95%
Traps: Enabled
Port
Powered Device
----
----------------
1/1
IP Phone Model A
2/1
Wireless AP Model
3/1
Console> show power inline ethernet 1/2
Port
Powered Device
----
----------------
1/2
IP Phone Model A
State
Priority
Status
-----
--------
------
Auto
High
On
Auto
Low
On
Auto
Low
Off
State
Priority
Status
-----
--------
------
Auto
High
On
Page 213
Power over Ethernet Commands
Classification [w]
-----------------
0.44 - 12.95
0.44 - 3.84
N/A
Classification [w]
-----------------
0.44 - 12.95