Table of Contents
Advertisement
IMPORTANT
Installer and Users please note:
These instructions should be read carefully and left with the user of the
product for future reference.
BEFORE USE
You must inspect the appliance including its cable and plug for any signs
of damage. If the product is damaged, DO NOT use it, and contact your
supplier immediately.
INSTALLATION
For free-standing use: Attach the feet to the underneath of the heater
using the four 12mm (½") screws.
To wall-mount: Referring to the diagram opposite, draw two horizontal
lines on the wall 255 mm (10") apart, the lower line more than 50 mm (2")
from the floor.
• On the upper line, drill holes 550 mm (21½") from the centre line, using
a 6 mm (¼") masonry bit, and insert a wall plug.
• On the lower line, drill holes 521 mm (20½") from the centre line using a
6 mm (¼") masonry bit, and insert a wall-plug.
• Fix the two hook-brackets to the upper holes using the 30 mm (1¼")
screws.
• Fix the two L-shaped brackets to the underside of the heater between
the first and second sets of slots, using the 12 mm (½") screws
• Hang the heater on the hook-brackets using the two 25 mm (1") slots.
• The L-shaped brackets will now line up with the lower holes in the wall.
Attach to the wall using the other two 30 mm (1¼") screws.
Page 2
Advertisement
Table of Contents
