Nautilus T618 Owner's Manual page 53

Condition/Problem
Fan will not turn on or will
not turn off
Fan will not turn on, but
Console operates
Unit rocks/does not sit
level
Thumping sound when
belt operates
Walking belt not aligned
Motor sounds strained
Hesitation or walking belt
slips when in use
Belt stops moving while
in use
Console continuously
cycles through program
screens
Workout results will not
sync with Bluetooth en-
®
abled device
Things to Check
Check data cable integrity
Check data cable
connections/orientation
Reset machine
Reset machine
Check for blockage of fan
Check leveler adjustment
Check surface under unit
Walking belt
Machine leveling
Walking belt tension and
alignment
Silicone lubrication on
walking belt
Belt tension
Safety key
Motor overload
Console is in demonstra-
tion mode
Current console mode
Total time of workout
All wires in the cable should be intact. If any are cut or crimped,
replace cable.
Be sure cable is connected securely and oriented properly.
Small latch on connector should line up and snap into place.
Unplug unit from electrical outlet for 3 minutes. Reconnect to
outlet.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada).
Unplug unit from electrical outlet for 5 minutes. Reconnect to
outlet.
Unplug unit from electrical outlet for 5 minutes. Remove mate-
rial from fan. If necessary, detach the Console to help with
removal. Replace the Console if unable to remove blockage.
Adjust levelers until machine is level.
Adjustment may not be able to compensate for extremely un-
even surfaces. Move machine to level area.
Walking belt needs to be used for wear in period. Sound will go
away after the wear in period.
Make sure the machine is level. Refer to the procedure for
leveling the machine in this manual.
Make sure the walking belt is centered and tension is correct.
Refer to the procedures for adjusting tension and aligning the
belt in this manual.
Apply silicone to the inner surface of the walking belt. Refer to
the belt lubrication procedure in this manual.
Adjust the belt tension at the rear of the machine. Refer to the
procedure for adjusting belt tension in this manual.
Plug Safety Key into Console. (See Emergency Stop Proce-
dure in the Important Safety Instructions section.)
Unit may be overloaded and draw too much current, which
causes power to turn off to protect motor. Refer to maintenance
schedule for belt lubrication. Make sure the walking belt tension
is correct, and start unit again.
If the above steps do not resolve the problem, contact Cus-
tomer Service (if inside US/Canada) or your local distributor (if
outside US/Canada).
Hold down the PAUSE/STOP button and Decrease button
together for 3 seconds.
Machine must be in Idle Mode to sync. Push the PAUSE/STOP
button until the Power-Up Mode screen is displayed.
A workout must be longer than 1 minute to be saved and
posted by the Console.
Solution
53