To Create A Hardware Striped Volume - Sun Microsystems SPARC Enterprise T1000 Administration Manual

Note – The logical device names might appear differently on your system,
depending on the number and type of add-on disk controllers installed.
▼

To Create a Hardware Striped Volume

1. Determine which disk is the default boot device.
From the OpenBoot ok prompt, type the printenv command, and if necessary the
devalias command, to identify the default boot device. For example:
ok printenv boot-device
boot-device =
ok devalias disk
disk
2. Type the boot net –s command.
ok boot net –s
3. Verify that the member disks are available and that there is not a volume already
created.
The server's on-board SAS controller can configure one RAID volume. Prior to
volume creation, ensure that the member disks are available and that there is not a
volume already created.
# raidctl
No RAID volumes found.
See "Physical Disk Slot Numbers, Physical Device Names, and Logical Device
Names for Non-RAID Disks" on page
The preceding example indicates that no RAID volume exists.
48 Sun SPARC Enterprise T1000 Server Administration Guide • April 2007
disk
/pci@7c0/pci@0/pci@8/scsi@2/disk@0,0
42.