Table 1-1 Ways Of Communicating With The System - Sun Microsystems SPARC Enterprise T1000 Administration Manual

The system console must be accessed through the system controller during initial
system installation. After installation, you can configure the system console to accept
input from and send output to different devices.
where they are discussed in the document.
Ways of Communicating With the System
TABLE 1-1
Devices Available
A terminal server attached to the
serial management port (SER
MGT).
An alphanumeric terminal or
similar device attached to the
serial management port (SER
MGT).
A TIP line attached to the serial
management port (SER MGT).
2 Sun SPARC Enterprise T1000 Server Administration Guide • April 2007
During After
Installation Installation
X X
X X
X X
X X
X X
X X
X X
X X
X
lists these devices and
TABLE 1-1
Further Information
"Accessing the System Controller" on
page 6
"Accessing the System Console Through a
Terminal Server" on page 9
"System Console OpenBoot Configuration
Variable Settings" on page 23
"Accessing the System Controller" on
page 6
"Accessing the System Console Through an
Alphanumeric Terminal" on page 13
"System Console OpenBoot Configuration
Variable Settings" on page 23
"Accessing the System Controller" on
page 6
"Accessing the System Console Through a
TIP Connection" on page 10
"Modifying the /etc/remote File" on
page 12