Sun Microsystems SPARC Enterprise T1000 Administration Manual page 26

If your network uses static IP addresses, type:
■
sc> setsc netsc_dhcp false
sc> setsc netsc_ipaddr ip-address
sc> setsc netsc_ipnetmask ip-netmask
sc> setsc netsc_ipgateway ip-address
If your network uses Dynamic Host Configuration Protocol (DHCP), type:
■
sc> setsc netsc_dhcp true
4. Type one of the following commands:
If you intend to use Secure Shell (SSH) to connect to ALOM CMT:
■
sc> setsc if_connection ssh
- If you intend to use Telnet to connect to ALOM CMT:
■
sc> setsc if_connection telnet
5. Reset the system controller so that the new settings take affect:
sc> resetsc
6. After the system controller resets, log in to the system controller and issue the
shownetwork command to verify network settings:
sc> shownetwork
To connect through the network management port, use the telnet or ssh (based on
the value you provided in Step 4) commands to the IP address you specified in
Step 3
8 Sun SPARC Enterprise T1000 Server Administration Guide • April 2007
of the preceding procedure.