What To Do If - Bosch Maxx WTL 6100 Instruction Manual And Installation Instructions

What to do if ...

What to do if ...
The Mu" indicator
lamp does not come on. l d
The dryer does not start.
The Water p" and
Mu" indicator lamps Mu" indicator lamps
are flashing.
There is water in the
water container overflow
cap.
Water is leaking out.
The door opens by itself.
d
Danger, electrical current.
Repairs must only be carried out by the after sales
service or an authorised expert.
If you cannot rectify a fault yourself, or a repair is ne
cessary:
q Turn the programme selector to Off.
q Remove the plug from the socket.
q Contact the after sales service (see page 25).
Cause
The dryer is not plugged in.
The Mu button has not been
pressed.
A fuse has blown in your home.
The Mu button has not been
pressed.
The door and/or maintenance flap
are not closed properly.
No programme has been set.
The ambient temperature is below
5 ºC.
The water container is full.
The water drainage hose is kinked.
The area between the overflow and
the overflow cap is blocked.
The door and/or maintenance flap
seals are dirty or damaged.
The catch is not engaged.
Solution
Plug in the dryer.
Press the button.
Reset/change the fuse.
Press the button.
Close the maintenance flap and the
door.
Select the programme you require
using the programme selector.
Increase the room temperature.
Empty the container (page 21).
Unkink the hose.
Wash out the container and the
overflow thoroughly with water.
Clean the seal or have it replaced
by the after sales service.
Push the door until you hear a click
as the locking catch engages.
23