Table of Contents
Advertisement
What to do if ...
One or more programme
status indicator lamps are
flashing.
g
The humidity in the room
has increased
significantly.
The contents did not dry
or the drying time was
y g
too long.
24
Cause
There has been a fault in the
programme sequence or operation.
The maximum drying time for the
programme has been exceeded.
The room is not sufficiently
ventilated.
The ventilation grille is obstructed.
The condenser unit has not been
inserted.
The condenser unit is clogged.
The filter is blocked.
The water container is full.
Water is not draining.
Ambient temperature above 30 ºC.
The ventilation grille is obstructed.
The wrong programme was
selected.
The appliance was installed in too
small a space.
A power failure of more than two
hours.
Solution
Clean the fluff filter and the
condenser unit (see pages 20 and
22).
Check the installation conditions
(see page 27).
Switch off the dryer, let it cool and
then switch it on again. Restart the
programme.
Clean the fluff filter and the
condenser unit (see pages 20 and
22).
Check the installation conditions
(see page 27).
Spin the laundry in the washing
machine at the maximum spin
speed.
Ensure sufficient ventilation.
Keep the ventilation grille clear.
Insert the condenser unit.
Clean the condenser unit
(see page 22).
Clean the filter (see page 20).
Empty the container (page 21).
Check the water drainage
(if applicable).
Ensure sufficient ventilation.
Keep the ventilation grille clear.
Use the table of programmes to
help you select the correct
programme (see page 16 onwards).
Ensure that cold air can circulate.
Restart the programme.
Hide quick links:
Advertisement
Table of Contents
