Setting The Tv On The Wall; Removing The Stand - Sharp LC-26GA5X Operation Manual

Preparation

Setting the TV on the wall

• You can mount the TV on the wall, using the optional AN-26AG1 bracket.
• For details, refer to the instructions supplied with the optional bracket.
CAUTION
• Installing the Liquid Crystal Television requires special skill that should only be performed by qualified service
personnel. Customers should not attempt to do the work themselves. SHARP bears no responsibility for improper
mounting or mounting that results in accident or injury.
<Example>
Hanging on the wall
Wall mount bracket. (See the bracket instructions for details.)

Removing the stand

For wall mounting with the optional AN-26AG1 bracket, remove the stand.
Before attaching/detaching stand
• Before detaching (or attaching) stand, unplug the AC cord from the AC outlet.
• Remove all terminal covers and connected cables.
• Lay the TV down on cushioning (such as a blanket) over a table.
• Make sure two or more people perform the operation.
CAUTION
• Do not remove the stand from the TV unless using an optional bracket to mount it.
1
Unfasten the four screws used to secure the
stand in place.
NOTE
• To attach the stand, perform the above steps in reverse order.
Regarding the angle when mounting the TV
on the wall
• The angle to which you can tilt the wall-
mounted TV is up to 20 degrees. Do not tilt it
more than the maximum angle.
• Tilt the wall-mounted TV slowly when adjusting
its angle.
2
Detach the stand from the TV.
(Hold the stand so it will not drop from the edge of
the base area.)
9