Appendix; Removing The Stand; Setting The Tv On The Wall - Sharp Aquos LC-37D40U Operation Manual

Appendix

Removing the stand

Before detaching (or attaching) stand, unplug the AC cord from the AC INPUT terminal.
CAUTION
• Do not remove the stand from the TV unless using an optional wall mount bracket to mount it.
Before attaching/detaching stand
• Before performing work make sure to turn off the TV.
• Before performing work spread cushioning over the base area to lay the TV on. This will prevent it from being
damaged.
1
Unfasten the four screws used to secure the stand in
place.
NOTE
• To attach the stand, perform the above steps in reverse order.

Setting the TV on the wall

CAUTION
• Installing the TV requires special skill that should only be performed by qualified service personnel. Customers
should not attempt to do the work themselves. SHARP bears no responsibility for improper mounting or
mounting that results in accident or injury.
Using an optional bracket to mount the TV
• You can ask a qualified service professional about using an optional AN-37AG2 bracket to mount the TV to the
wall.
• Carefully read the instructions that come with the bracket before beginning work.
Hanging on the wall
AN-37AG2 wall mount bracket. (See the bracket instructions for details.)
Vertical mounting
NOTE
• Detach the cable clamp on the rear of the TV when using the optional mount bracket.
48
hex key
Angular mounting
2
Detach the stand from the TV.
(Hold the stand so it will not drop from the edge of the
base area.)
About setting the TV angle
Angle of TV
LC-37D40U
LC-45D40U
0° or 5°
0°