Hardware Hookup - Crestron TPS-4500IMC User Manual

Crestron TPS-4500IMC
NOTE: When daisy chaining network units, always twist the ends of the
incoming wire and outgoing wire which share a pin on the network
connector. After twisting the ends, tin the twisted connection with solder.
Apply solder only to the ends of the twisted wires. Avoid tinning too far
up or the tinned end becomes brittle and breaks. After tinning the twisted
ends, insert the tinned connection into the network connector and tighten
the retaining screw. Repeat the procedure for the other three network
conductors.

Hardware Hookup

The TPS-4500IMC serves as an interface between the touchpanel and the
Cresnet system. Refer to the illustration on the next page for proper
connections; apply power last. When making network connections to the
CNX Generation control system or Cresnet peripherals, refer to "Network
Wiring" on page 4 for details. It is not necessary to make connections to a
video source unless the TPS-VID has been installed into the touchpanel
and a video window object resides on a page within the uploaded
VisionTools™ Pro-e project.
Operations Guide - DOC. 5890
Interface Module
Interface Module: TPS-4500IMC • 5