Table of Contents
Advertisement
Interface Module
Hardware Hookup for the TPS-4500IMC
* Connect to a video source only if the TPS-VID expansion card is
installed in the touchpanel. The BNC connector and screw terminal mini
Phoenix connector is connected in parallel. Possible options are no
connection, balance video using twisted pair cable, or unbalanced video
using coax cable. Depending on the option, the two jumpers on the
NTSC/PAL VIDEO six-pin connector remain attached or are removed.
CAUTION: If there is no video, do not make a connection to this port,
but leave connector and jumpers attached to the NTSC/PAL VIDEO six-
pin connector on the TPS-4500IMC. Failure to do so may damage the
TPS-4500IMC.
Video balance is determined by external connections. Refer to the two
diagrams on the next page.
6 • Interface Module: TPS-4500IMC
CONNECT TO TPS-4500
CRESTRON
TPS -4500 IMC
NET
COMP
24
Y
Z
G
CONNECT TO CNX
GENERATION
CONTROL SYSTEM
OR CRESNET
PERIPHERALS
Crestron TPS-4500IMC
NTSC/PAL VIDEO
C
_
Y
C
+
S
* CONNECT
TO VIDEO
SOURCE
Operations Guide - DOC. 5890
COMP
Y
_
+
S
Advertisement
Table of Contents
