Table of Contents
Advertisement
Wall Mount 2-Way RF Compact Color Touchpanel
10
Wall Mount 2-Way RF Compact Color Touchpanel: STX-1550CW
NOTE: The cable components in the figure below are part of the SmarTouch
Programming Kit (ST-PK). If available, use these components.
Typical Connection Diagram when Loading a Program from the ST-CP
CRESTRON
15710
(PART OF ST-PK)
15717
(PART OF ST-PK)
NET
P C
COMA
COMB
12VDC
IR OUT
.5A
A
B
C
CRESTRON ELECTRONICS INC. N.J. 07626
1.
Before making any connections to the touchpanel, verify that control
system is properly connected to the PC (for ST-CP, use cable 15717
and adapter) and powered on.
2.
Refer to the programming cable specifications diagram on the next
page for connection to the NET port. Attach the stereo connector end of
the programming cable, (for ST-CP, use cable 15710) to the
touchpanel.
3.
Attach the RJ11 connector end of the programming cable, (for ST-CP,
use cable 15710) to the connector labeled NET on the control system.
4.
Attach the appropriate external AC power pack or equivalent to
touchpanel and plug into outlet.
5.
Use Crestron VT Pro-e software to upload the panel design project to
the touchpanel. Refer to the software help file for upload settings.
6.
After the touchpanel project has been uploaded, disconnect the
programming cable. The touchpanel communicates with the control
system via RF signals.
Crestron STX-1550CW
TOUCHPANEL
AC POWER PACK
(CRESTRON MODEL
OR EQUIVALENT)
SERIAL PORT,
USE ADAPTER
(PART OF ST-PK)
RF
D
ST-CP
Operations Guide - DOC. 5849
NOTE:
UNITS IN THIS ILLUSTRATION
ARE NOT DRAWN TO SCALE.
PC
Advertisement
Table of Contents
