Panasonic CF-W4 Series Reference Manual page 145

Setup Utility
Security Menu
Execute-Disable Bit Capability
• When [Execute-Disable Bit Capability] is set to [Enable], it means that this computer supports
hardware-based Data Execution Prevention (DEP). It should usually be set to [Enable].
DEP is a set of hardware and software technologies that perform additional checks on memory
to help prevent malicious code from running on a system.
Password on boot
• Select whether you will need to input ([Enable]) or not ([Disable]) the Supervisor Password or
the User Password on booting.
SD Startup
• Select whether to use an SD memory card instead of entering the password on booting
([Enable]) or not ([Disable]).
• When registered SD memory card, this is set to [Enable].
• Cannot be set when [Password on boot] is set to [Disable].
SD Setting Method
• Select whether to set an SD memory card to [Leave Set] or [Set and Eject] when an SD memory
card is used instead of entering the password.
• This can be set only if [SD Startup] has been set to [Enable].
• Cannot be set when [Password on boot] is set to [Disable].
Clear registered SD card
• Clear the registration from all registered SD memory cards not to be used instead of entering
the password on booting.
NOTE
When the Setup Utility is started up with the User Password, only a limited number of
items can be displayed and set. (
When starting up the computer, if the message [Hard disk access is prohibited "Hard
Disk lock"] appears, start up the Setup Utility, and change the settings to match the
details when the hard disk protection was set.
[SD Startup], [SD Setting Method] and [Clear registered SD card] will be displayed
only when an SD memory card has been registered. (
page 138)
page
(An underline indicates the factory default settings)
145
103)
Disable
Enable
Disable
Enable
Disable
Enable
Leave Set
Set and Eject
To the sub-menu