Start-Up Checklist - Bryant DuraPac 580F Series Installation, Start-Up And Service Instructions Manual

I. PRELIMINARY INFORMATION
MODEL NO. _______________________________________
DATE: _____________________________________________
UNIT NO.: _________________________________________
II. PRE-START-UP (insert checkmark in box as each item is completed)
VERIFY THAT ALL PACKING MATERIALS HAVE BEEN REMOVED FROM UNIT
REMOVE SHIPPING TIE DOWN BANDS ON COMPRESSOR (SIZE 150 AND 151 ONLY) PER
INSTALLATION INSTRUCTIONS
VERIFY THAT CONDENSATE CONNECTION IS INSTALLED PER INSTALLATION INSTRUCTIONS
CHECK ALL ELECTRICAL CONNECTIONS AND TERMINALS FOR TIGHTNESS
CHECK GAS PIPING FOR LEAKS
CHECK THAT RETURN-AIR FILTERS ARE CLEAN AND IN PLACE
VERIFY THAT UNIT INSTALLATION IS LEVEL
CHECK FAN WHEELS AND PROPELLERS FOR LOCATION IN HOUSING/ORIFICE AND SETSCREW TIGHTNESS
ENSURE BELT TENSION IS CORRECT AND BLOWER PULLEYS ARE PROPERLY ALIGNED.
III. START-UP
ELECTRICAL
SUPPLY VOLTAGE
COMPRESSOR AMPS
COMPRESSOR AMPS
INDOOR-FAN AMPS
TEMPERATURES AND PRESSURES
OUTDOOR-AIR TEMPERATURE
RETURN-AIR TEMPERATURE
COOLING SUPPLY AIR
GAS HEAT SUPPLY AIR
GAS INLET PRESSURE
GAS MANIFOLD PRESSURE
REFRIGERANT SUCTION PRESSURE
REFRIGERANT TEMP. (SUCTION) PRESSURE
REFRIGERANT DISCHARGE
DISCHARGE TEMPERATURE
VERIFY REFRIGERANT CHARGE USING CHARGING TABLES
VERIFY THAT 3-PHASE SCROLL COMPRESSOR ROTATING IN CORRECT DIRECTION
(580F103,121,150,151 ONLY)
Copyright 2004 Bryant Heating & Cooling Systems

START-UP CHECKLIST

(Remove and Store in Job File)
L1-L2 L2-L3
L1 L2
L1 L2
L1 L2
DB
DB
DB
DB
SERIAL NO. ___________________________________________
TECHNICIAN: _________________________________________
JOB LOCTION:_________________________________________
JOB NAME: ____________________________________________
L3-L1
L3
L3
L3
WB
WB
IN. WG
IN. WG (HI FIRE)
PSIG — CIRCUIT NO. 1
CIRCUIT NO. 1
PSIG — CIRCUIT NO. 1
°F/C — CIRCUIT NO. 1
CL-1
IN. WG (LO FIRE)
PSIG — CIRCUIT NO. 2
CIRCUIT NO. 2
PSIG — CIRCUIT NO. 2
°F/C — CIRCUIT NO. 2
CATALOG NO. 5358-024