Removing Prints From Finisher Sr5090/Booklet Finisher Sr5100 During Printing; Removing Prints From Finisher Sr5110/Booklet Finisher Sr5120 During Printing Or When In Standby State - Ricoh Pro C5300S Operator's Manual

Hide thumbs Also See for Pro C5300S:

Table of Contents

1. Getting Started

Removing Prints from Finisher SR5090/Booklet Finisher SR5100 during

This section describes how to suspend a large copy or print job when using Finisher SR5090 or Booklet

Finisher SR5100 with the cooling fan unit installed.

Depending on the image you are copying or printing, prints might not stack properly. If this happens,

suspend the job, remove the prints and then restart the job.

Press the [Suspend / Resume] key near the paper outlet port.

1. [Suspend / Resume] key

Remove the stack of paper from the finisher shift tray.

Press the [Suspend / Resume] key to restart the print.

• You can suspend copying or printing only when the finisher shift tray is selected as the output tray.

Removing Prints from Finisher SR5110/Booklet Finisher SR5120 during

Printing or When in Standby State

• Notes on removing paper from the shift tray