Chapter Ix Storage And Load System; Setup Storage And Load; Waveform Storage And Load - UNI-T UTD2000 Series User Manual

Chapter IX Storage and Load System

User can enter the storage and load menu by pressing the STORAGE button.
Press STORAGE to go to the type menu. There are three types to choose from:
Setup,Wave and Bitmap

9.1 Setup storage and load

Press the Storage button, then Press F1 to choose storege type Setup , and you will
see the following menu.
Table 9-1 Setup storage menu
Function Menu Setting
Type Setup
1~20
Dest
1~200
Save ——
Load

9.2 Waveform storage and load

Press the Storage button, then Press F1 to choose storege type Wave , and you will
see the following menu.
Table 9-2 Waveform storage menu (Page 1)
Function Menu Setting
Type Wave
CH1
Source
CH2
1~20
Dest
1~200
Save ——
Next 1/2
Figure 9-1 Function Key of STORAGE
Description
Select to store a DSO setting
Maximum 20 front panel setups can be storedwith themultifunction control knobon the
front panel
Set the waveform storage position on the USB device (This function can be enabled
only when theUSB device is plugged in and the disk menu is set to"USB")
Store waveform
Recall the setting
Description
Select to store a acquired waveform
Select waveforms from CH1 channel to be saved
Select waveforms from CH2 channel to be saved
Maximum 20 front panel setups can be storedwith themultifunction control knobon the
front panel
Set the waveform storage position on the USB device (This function can be enabled
only when theUSB device is plugged in and the disk menu is set to"USB")
Store waveform
Get to the next page
39
UTD2000 Series User Manual