Chapter VI Display System
User can change the display setting of the DSO by pressing the DISPLAY button of
the UTD2000 series DSO as figure below.
After press DISPLAY button, the function menu will change to the display setting for
the DSO.
Table 6-1 Display Menu
Function Menu
Setting
Vector
Types
Dots
YT
Format
XY
Off
1s
Persist
2s
5s
Infinite
——
Brightness
1%-100%
6.1 XY Mode
The phase difference between the two signals of the same frequency can be easily
observed by Lissajous method. The following chart gives the observation of phase
difference.
Figure 6-1 Function Keys of Display System
Description
Display as vector of sampled data points
Display any of the sampled data points
Display Y-axis as voltage level of input signal and X-axis as time
Display Y-axis as CH2 voltage level of input signal and X-axis as CH1 voltage
level of input signal
Real-time updating (Display) of the acquired signal.
Display the acquired signal every 1s
Display the acquired signal every 2s
Display the acquired signal every 5s
Accumulate display all the acquired
Set the brightness of the waveform by multi-purpose node between 1%-100%
brightness.
33
UTD2000 Series User Manual