Setting Probe Rate - UNI-T UTD2000 Series User Manual

Figure 2-4 Waveform Display When Setting Bandwidth throttling in OFF Position
If you press F2 again to set the BW Limit as ON, the noises or high-frequency
component over 20MHz in measured signal shall be attenuated, as waveform display
shown in figure below.
BW Limit Mark
Figure 2-5 Waveform Display When Setting Bandwidth throttling as ON

2.3 Setting probe Rate

In order to cooperate with attenuation coefficient setting of probe, it is required to set
the probe attenuation coefficient in channel function menu. If the probe attenuation
coefficient is 10:1, the probe coefficient in channel function menu shall be set to be 10×
and vice-versa.
UTD2000 Series User Manual
18
BW Limit ON