Table of Contents
Advertisement
ESC d
[Function]
Request Printer Status
[Code]
<1B>H<64>H
[Outline]
This command sends the 1-byte status messages shown below in the P-250 mode, P-900R
mode, and 42-column mode. This command is valid only for the serial interface.
[Caution]
This command is ignored for the parallel interface, and in the P-200 mode and 40-column
mode. If the paper runs out or there is a mechanical error, the data may not be received.
[See Also]
ESC a
ESC e (n) ;
[Function]
Set Right Margin
[Code]
<1B>H<65H>(n)<3B>H
[Range]
1 (n) 42 (<30>H
[Outline]
In the P-250 mode and P-900R mode, this command controls whether the characters should
be printed or at which position of the line they should be printed. If the parameter is set
between 1 and 42, the printer will print automatically when the n-th printable character is
received. If the parameter is set beyond these limits, this command will be ignored.
[Caution]
Be sure to add ";"(<3B>H) to the end of the parameter. The command is ignored in other than
the P-250 mode and P-900R mode.
[Default]
The characters are printed after the LF command is received in the 42-column mode.
[Sample Program] When setting the right margin to 10
ESC e 10;
<1B>H<65>H<31>H<30>H<3B>H
Bit
Code
0
L
Paper end
1
X
Not defined
2
X
Not defined
3
X
Not defined
4
X
Not defined
5
1
Not defined
6
F
Mechanical error
7
P
n <39>H)
LPRINT CHR$(&H1B)+"e10;" ;
Function
With paper
Without error
Parity
45
iDP3310 User's Manual
P-250,P-900R, 42ch
Value
0
1
Without paper
- -
Fixed at 1
With error
- -
- -
P-250,P-900R
CITIZEN
Advertisement
Table of Contents
