Removing The Rechargeable Battery - Remington The Works Hair Clipper Kit Manual

ENGLISH
STEP 4 – TOP OF THE HEAD
• Use the longer length comb attachment and set it to 30 mm then cut hair on top of the
head against the direction in which the hair normally grows.
• Always work from the back of the head.
STEP 5 – THE FINISHING TOUCHES
• Use the clipper without an attachment comb for close trimming around the base and
sides of the neck.
• To produce a clean straight line at the sideburns, reverse the hair clipper.
• Place the reversed clipper at right angles to the head, tips of the blades lightly touching
the skin and then work downwards.
CARE FOR YOUR HAIRCLIPPER
• Your clipper is fitted with high quality blades.
• To ensure long lasting performance of your clipper, clean the blades and unit regularly.
• Always keep the attachment guide comb on the trimmer blade.
AFTER EACH USE
• Ensure the appliance is switched off and
• Brush the accumulated hair from the blades and body of the clipper. Do not submerge
the clipper in water.
• To clean unit, wipe with a damp cloth and dry immediately.
• Place a few drops of cutter or sewing machine oil onto the blades. Wipe off excess oil.
EVERY SIX MONTHS
• Hold the hair clipper in one hand so that the blades are at the top, and the front of the
hair clipper is facing you.
• Place your thumb of the opposite hand underneath the blades at the front of the unit,
hold the back of the blade set with your fore finger and middle finger and firmly press
upwards with your thumb. The blade set will detach from the hair clipper.
• Brush the accumulated hair from the hair pocket and blades.
• Replace the blade set by inserting the notch (on the inside at the bottom of the blade
set) into the groove of the hair pocket and firmly push down with the palm of your hand
until you hear an audible 'click' and the blade set is locked into place.

REMOVING THE RECHARGEABLE BATTERY

We strongly recommend that a professional removes the rechargeable battery. Parts of the
shaver case, and tools have sharp edges and may cause injury if not handled correctly.
• The rechargeable battery must be removed from the appliance before it is scrapped.
• Disconnect the charging adapter before removing the battery.
1. Ensure that the battery is fully discharged. To do this, operate the device until it stops.
2. Remove the blade assembly.
6
unplugged from the charger before cleaning.