Troubleshooting; Battery Removal - Remington The Works Hair Clipper Kit Manual

Table of Contents

Advertisement

ENGLISH
Insert the cutting unit gently into the outer ear canal opening.
Gently rotate the trimmer in a circular motion.
Avoid inserting the cutting unit more than 6mm into your ear canal.
CARE FOR YOUR TRIMMER
Care for your product to ensure a long lasting performance. We recommend that you
clean your trimmer after each use.
For best results, keep trimmer running while running it under the tap.
Dry off excess water.
Do not submerge in water as damage will occur.

TROUBLESHOOTING

The trimmer is not running but has battery power left:
If the trimmer is not running it may need cleaning; look for and remove any dried debris
from the cutting blades.
AFTER EACH USE
Rinse the accumulated hair from the cutters as noted above. Ensure all debris is
removed from between the blades and shake off excess water.

BATTERY REMOVAL

The battery must be removed from the appliance before it is scrapped.
Rotate the battery compartment cap approximately ¼ turn anti-clockwise then pull off.
Remove the battery from the battery compartment.
Place the cap back on the unit opposite to how it came off and rotate clockwise until the
cap snaps into place.
The battery is to be disposed of safely.
RECYCLING
W
8
To avoid environmental and health problems due to hazardous
substances, appliances and rechargeable and non-rechargeable
batteries marked with one of these symbols must not be disposed of
with unsorted municipal waste. Always dispose of electrical and
electronic products and, where applicable, rechargeable and
non-rechargeable batteries, at an appropriate official recycling/
collection point.

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hc910

Table of Contents