Inserting Batteries - Remington The Works Hair Clipper Kit Manual

Table of Contents

Advertisement

3. Remove the 4 screws from rear housing.
4. Pry open the top housing.
5. Pry and open the top housing.
6. Take out the inner assembly to expose the batteries.
7. Disconnect the battery from the circuit board.
The battery must be disposed of at an appropriate official recycling/collection point.
Do not attempt to operate the device once you have opened it.
PRECISION TRIMMER, AND NOSE AND EAR TRIMMER

INSERTING BATTERIES

Both trimmers require 1 'AA' alkaline battery (first one included).
Ensure the product is switched off.
To open the battery compartment, turn the base of the unit approximately 1cm
counter-clockwise and pull it off.
Insert the battery into the unit, positive end first.
Replace the base and turn it 1cm clockwise to lock it into place.
Note: Your trimmer will not work if the batteries are inserted incorrectly.
INSTRUCTIONS FOR USE
Note: Do not apply excessive pressure as this damages the trimmer head and may cause skin
injury.
TO REMOVE HAIR FROM NOSE
Select the nose and ear trimmer.
Insert trimmer's cutting unit gently into the nostril.
Gently move the trimmer in and out of the nostril and at the same time rotate the
trimmer.
Avoid inserting the cutting unit more than 6mm into your nostril.
TO TRIM SIDEBURNS
Select the precision trimmer.
Turn the trimmer on.
Gently guide the cutting unit to your sideburns holding the unit horizontally at a 90
degree angle to the sideburns.
Trim the sideburns moving the trimmer slowly and carefully, to ensure that you do not
accidentally cut hairs that you do not intend to trim.
Note: It is not recommended that you use the trimmer to define or trim the eyebrows.
TO REMOVE HAIR FROM EAR
Select the nose and ear trimmer.
ENGLISH
GB
DE
NL
FR
ES
IT
DK
SE
NO
FI
PT
SK
CZ
PL
HU
RU
TR
RO
GR
SI
HR
SR
UA
BG
AE
7

Advertisement

Table of Contents
loading

This manual is also suitable for:

Hc910

Table of Contents