Table of Contents
Advertisement
PCM-D10
2-17. SW_L BOARD
Note 1: If the SW_L board was replaced, make sure to refer to "BLUETOOTH CONNECTION
CHECKING METHOD" on page 10 and check the Bluetooth connection.
top side
boss
hole
terminal
side
hole
1 four screws
(Z1.7
4.5)
2-18. CHASSIS (MAIN)
adhesive sheet (EL)
6 cushion (SP)
bottom side
39
front side
3 flexible flat cable
(14P) (CN851)
2 Remove the SW_L board block
in the direction of the arrow.
4 SW_L board
Note 2: When installing the SW_L board,
align the two bosses and two holes.
top side
guide line
5 chassis (main) block
top side
7 chassis (main)
bottom side
How to install the flexible flat cable
Insert the flexible flat cable straight into the interior.
There is a possibility that using this unit without the
connector correctly installed will damage it.
boss
Insert straight into the interior.
flexible flat
cable
colored line
connector
Insert at a slant.
bottom side
flexible flat
cable
colored line
connector
3 main plate (PWB)
1 adhesive sheet (EL)
4 six screws
(Z1.7
4.5)
Turn over.
Sony CONFIDENTIAL
For Authorized Servicer
OK
NG
NG
Insert only part way.
flexible flat
cable
colored line
connector
2 three screws
(Z1.7
4 screw
top side
rear side
4.5)
(Z1.7
4.5)
SYS SET
Advertisement
Table of Contents
